(4)Suggestions and basis for rectification

更新于 2026年11月22日 版权声明
(4)Suggestions and basis for rectification

1)The correct donning sequence,according to the“Hospital Isolation Technical Specifications”and“Technical Guide for the Prevention and Control of New Coronavirus Infection in Medical Institutions(1st Ed.)”,in the process of putting on and taking off protective equipment is to don PPE before goggles.It is recommended that during doffing,eyes should be kept closed when removing goggles to minimize eye exposure.In addition,for operations such as specimen collection,if using a protective face shield,you can chooseto wear goggles first and then PPE.

2)For the fogging of goggles,the best method is to wear anti-fog goggles,but if available goggles are not the anti-fog type,the following methods can be adopted according to our experience.①Apply hand sanitizer on the lens,rinse it with water,and dry it for later use; ②Apply the inner surface of the goggles evenly with detergent,and leave them to dry naturally; ③Apply a thin layer of iodine solution to the inner surface of the goggles(Figure 4-5).It is advisable to choose a method that does not affect sight or stain the goggles.

3)The correct way to remove goggles is to slightly lower your head and close your eyes,hold the rear strap with both hands and gently remove the goggles from the back(Figure 4-6).

4)Disinfecting and cleaning of reusable goggles.Using chlorine-containing disinfectant as an example,configure the effective chlorine 1,000 mg/L-2,000 mg/L chlorine-containing disinfectant to soak for at least 30 minutes,and then rinse it thoroughly.Use a chlorineconcentration test strip to detect residual chlorine concentration,which must be lower than the lowest limit.Dry naturally or use drying equipment(temperature:65℃-75℃).(https://www.daowen.com)

Figure 4-5 Apply a thin layer of iodine solution to the inner surface of the goggles

Figure 4-6 Specification steps for removing goggles

✍AI写作